AMP CERTI-LOK hand crimp tool frame, Model 169400/58194-1. Supplied with AMP 58195-1 & 58195-6 Crimp Die Sets, 24-28 AWG.The 58195-6 Die Set is missing one of the spring loaded pins. The 58194-1 Hand tool & 58195-1 Die set are 100% functional. AMP CERTI-LOK Hand Tool Frame Assembly 169400 is designed to accept crimping die assemblies which crimp PIDG and PLASTI-GRIP terminals, PIDG "window" splices, SOLISTRAND terminals and splices, and Multimate Type III(+). Instructions included for crimp die set installation procedure. The tool features a ratchet, ratchet release lever, ratchet adjuster, locator/wire stop and a terminal stabilizer.
The stabilizer and locator are specific to each die assembly when used in the hand tool. When installing a die assembly, the accompanying stabilizer and locator must be installed on the tool for proper functioning.
The ratchet release lever enables the tool operator to open the partially closed tool handles when necessary. During crimping, the locator correctly positions wire and terminal/splice or contact.The stabilizer prevents the product from bending during the crimping procedure. The locator and product insulation are colour-coded for a given wire range as listed in the instructions supplied with the die assembly. The product bearing the colour-coded insulation is crimped in the matching colour-coded crimping enclosure of the dies. The ratchet adjuster is used to control the crimp height of the products wire/insulation. AMP Crimping die assemblies 58195-1 & 58195-6 are used to crimp the SDL (Sheilded Data Link) plug connectors. The die assemblies are designed to be used in CERTI-LOK Hand Crimping Tool 58194-1.
Each die assembly consists of an upper die (crimper) and lower die (base plate) joined by two spring-loaded pins. The upper die features three crimpers which enter corresponding slots in the plug connector housing and crimp the cable strain reliefs and contacts. The lower die acts as a base for the connector and features keyed guides which provide secure positioning for the connector during the crimping procedure. The die pins and compression springs provide alignment for the dies in die disengagement when the tool assembly is re-opened after crimping.
PN: 169400 & 58194-1 refers to CERTI-LOK Hand Tool Frame Assembly. PN: 58195-1 refers to Die Assembly. PN: 58195-6 refers to Die Assembly [Missing one spring-loaded pin]. Full data-sheet & instructions included with tool. Tool Dimensions: 280mm x 80mm x 60mm Weight: 700g.Tel: 023 80866377 Vat Registration No. This item is in the category "Business, Office & Industrial\Hand Tools\Electrical Tools\Hand Crimpers & Strippers".
The seller is "series4clearanceseries4limited" and is located in this country: GB. This item can be shipped worldwide.