AST605 Brake Fluid Bleeder Extractor Car Pulsating Brake Oil Changer Single Clutch Slave Cylinders Fast Brake Exchanger Oil Pump Machine for 220V. It is a brake fluid exchanger equipment. The physical principle is to suck the brake fluid from the new fluid storage tank through a pump, and continuously pump it into the automobile brake fluid container at a specified pressure. This product only requires one person to operate, and allows you to easily use and change the brake oil. It can change the oil of four sub-pumps at the same time.
After setting the working environment, just pressing the'start' button for simple operation. Built in Pressure Monitoring System. The range of pressure is 0-3 BAR.If pressure cannot be built up or the pump sucks in air, the pump will automatically shut down. When the time comes, the air inlet is equipped with a water separation and filtration device, which can separate the water in the air, avoid mixing with oil, and ensure the quality. Autool AST 605 is suitable for European, American and Asian car brake fluid tanks, it almost can apply for all vehicles. Brake fluid is taken from its container by a pump operating at up to 3.0 bar pressure and is continuously pumped into the brake fluid reservoir. The individual wheel brake cylinders can then be drained of their used brake fluid until the new brake fluid comes through.
You thus avoid the regular emptying and filling operations, in contrast to conventional systems and also avoid any resulting water absorption in the brake fluid. The brake maintenance device is to be used exclusively for filling and draining of brake fluid for brakes and clutches on motor vehicles. Any other use is considered beyond the device's intended purpose and is prohibited.
The brake maintenance device should be installed on a flat surface. Make sure that the filling hose is not under any mechanical tension, for example when the vehicle is raised on a hydraulic lift. With the startup procedure and operation, the area around the brake maintenance device becomes its workplace. Otherwise, there is no fixed workplace for the brake maintenance device. How to adjust working pressure correctly.
When the device is out of factory, the working pressure of the pressure regulator is set to 11.5 bar, to ensure that the liquid storage chamber does not deform while changing liquid, thereby ensuring the tightness of the secondary sealing ring. In addition, it is also feasible to exhaust or change the liquid at a lower working pressure by adjusting the pressure and the size switch. In special circumstances, while operating under a higher working pressure, be aware of the excessive pressure adjustment, which may damage the brake master cylinder of the brake system. Voltage:220-240V; 50/60Hz or 110-120V 50/60Hz.
Flow Rate: 1.2L/M Working Pressure: 0.6-3.0 bar Container Empty Protection: Yes Filling Hose Length: 3.5m Noise: 70dB Dimension in mm: 285×230×370mm. Note: no need to start the vehicle for the operation. Raise the car to a suitable height so the drive wheels are not on the ground. Connect the four oil pots of the device to the car brake cylinder, and loosen the exhaust screw of the brake cylinder to ensure that oil flows out.Pour in 2L new brake fluid from the fuel filler port of the equipment, and find the matching model connector to connect to the fuel filler of the brake master cylinder. Connect to 12V car power and turn on the power switch button. Press the Vacuum Switch button.
Press the Fuel Switch button to change the brake fluid. During the oil changing process, look at the car brake oil tank mouth, if the refuel is too slow, press the acceleration switch button on the device to accelerate refueling; if it's too fast, press the deceleration switch button to slow down. After the oil change is completed, the used oil in the tank of the equipment must be drained clean. 1 AUTOOL AST605 Automotive Brake Fluid Bleeder Main Unit. The item "AUTOOL AST605 Electric Car Brake Fluid Bleeder Oil Exchange Machine Four Pump" is in sale since Monday, August 30, 2021.
This item is in the category "Vehicle Parts & Accessories\Garage Equipment & Tools\Hand Tools\Other Hand Tools". The seller is "fx-tul_official_store" and is located in Leicester. This item can be shipped to United Kingdom.