Electrical Hand Tools

Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty

Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty

Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty   Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty
Overload protection: When the load exceeds the rated load automatically stop working, protect the product from damage and operator safety. Selection of high-quality four-pole carbon brush 12V DC motor, torque strong, powerful. Static: 1: 1.5 times. 1, electric charge use: Ô« the car parked on the level of the road, the engine flameout, and do not forget to tighten the hand brake. Ôµ put the electric jack placed in the tires near the body under the steel beam, and the top of the electric jack on the bottom of the car under the support point, so that the electric jack can be safe and effective lifting. (3) Connect the electric jack to the 12V power supply in two ways: ÔÊ use cigarette lighter connection: one end of the cigarette lighter plug into the cigarette lighter socket, the other end of the 5.5mm plug into the electric jack on the 5.5mm plug seat. (Note: cigarette lighter fuse rated current shall not be less than 10A) ÔÁ Use the vehicle battery to connect directly: Insert one end of the cigarette lighter plug into the cigarette lighter socket at one end of the battery clamp, and hold the red clip on the other end of the battery clip and hold the battery "+" (positive) Battery "-" (negative) connected, and then plug the other end of the cigarette lighter plug 5.5mm plug into the electric jack on the 5.5mm plug seat. Ôá use the operation: to determine the first few steps to do a good job, you can start the lifting operation. Hold the remote control and press the button on the remote control as needed. "Ð_" means rising, "Ð_" means descent, "ÐÁ" means stop.

Ôü in the process of jacking up, should carefully observe the jacking dynamic, to ensure that the electric jack is not tilted until the wheel and the ground away from the 20mm, the wheels can be free to stop when lifting, replace the tires. 2, the use of electric wrench: Ô« When the replacement wheel leaves the ground, connect the electric wrench to the power supply (insert the 5.5mm power plug on the electric wrench directly into the 5.5mm plug of the cigarette lighter plug).

(2) Select the appropriate sleeve, the square hole into the top of the electric wrench on the square head, you can release or tighten the bolt. Ô¦ according to the required direction of work, choose loose, tight switch. With the thumb to hold the corresponding direction switch, hear 1-2 times "despair, despair" after the crash can release the thumb, the whole process about 2-3 seconds. 1 X Manual Remote Control. 1 X Battery Power Cable.

2 X Double-Headed Sleeve (17-19 21-23). 1 X Cigarette Lighter Power Cable. 1 X Pair Of Gloves. The item "Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty" is in sale since Sunday, September 10, 2017.

This item is in the category "eBay Motors\Automotive Tools & Supplies\Hand Tools\Other Automotive Hand Tools". The seller is "kanzezolstore" and is located in China. This item can be shipped worldwide.

  • Brand: Unbranded/Generic
  • MPN: Does Not Apply
  • Country/Region of Manufacture: China


Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty   Automotive Electric Car Jack Lift Van Garage 140mm-430mm 12V DC Heavy Duty