KD-5-0 Cloth fabric curtain fabric, nylon polyester fabric, filter cloth, electric cutting machine, Plastic cutting blade. Power cord length: 2.5M.
Three different types of blades. Cutting diameter cable within 2cm cut flat braid, fracture flat, no loose wire. Cutting plate with synthetic fiber fabrics can no mat cutting and welding incision.
Cutting cloth toys or tons of bags sewing sliver, melt fracture. Especially suitable for processing canvas, rain tarpaulin and cloth. (Thickness of 0.3mm or more synthetic fabrics) fabric cutting all kinds of fabrics (glass yarn, snow yarn, plush fabrics, velvet fabrics, decorative fabrics, ice silk ice silk material, satin, satin water, flashlight cloth, Choi cloth, sand release, shade cloth, chiffon cloth, high-wire cloth,dex fabric, Symphony laser cloth, shirt linings, Leisi fabrics, soft mesh gauze, Oxford, dance cloth, Riboud, mesh gauze, silk chiffon, clothing, banners, silk, chemical fiber fabrics, velvet, advertising cloth, nonwoven fabric, nylon fabric, wallpaper mural plastic sheeting) adjudged side hot mouth, to make products smooth, square mouth, not from wire-free and welding the cut edges.Lightweight (only 270 grams handle) with power adjustment knob. After cooling the tool, unscrew the nut. The two knife blades are inserted into the two legs knife, tighten the nut. Ensure full access to the blade and knife holder. If the knife legs were not installed correctly, the blade will not be heated.
Temperature adjustment wheel points 16, the wheel raised Lise shorter, smaller output power. Avoid direct contact with two tool holder cause a short circuit.The temperature control knob to the middle position, the blade on the cutting object, then press the trigger. Preheat 3 seconds to cut. It is recommended to test the waste.
When cutting is best to keep the temperature and speed of harmonization. If you smoke too much, it may be because the cutting blade speed is too slow or the temperature is too high. This may cause irregular cutting path, not flat, this situation, you can lower the temperature or the cutting blade intermittently release the switch. When finished cutting the distance 3-5CM, release the switch. When cutting, the exposed portion of the blade should not be more than 2 cm, if the exposed portion is too long, the blade may be bent due to overheating.Use wire brush to clean the blades. Always use this tool in ventilation. Do not burn residual debris on the blade, or blade will bend. Do not dry blades, please contact cutting was then heated. Do not touch the blade, not the blade is placed in the hot clothing, or near flammable materials.
Please handle blade after blade cooling, in order to avoid accidental injury. Do not make a red-hot blade without cutting materials. Super power output will overheat the blade deformation may also cause overheating damage the knife tool. Adjust output power of reasonable cause appropriate cutting speed. Return package must be in the original packaging, everything must be in new condition.
Your satisfaction is our goal. The item "3 in 1 KD-5-0 Cloth fabric cutter, electric cutting machine plastic cuter blade a" is in sale since Thursday, May 28, 2015. This item is in the category "Industrial\Hand Tools\Other". The seller is "mechsonic" and is located in CN,CN. This item can be shipped worldwide.